Vita Spa L100 Series Owner's Manual download pdf (Page 20)

OPTIONAL FEATURES

A. CIRCULATION PUMP (OPTION)

SETTING CIRCULATION PUMP

You are given the choice between 12

forced hours of circulation or 24 forced

hours, regardless of water tempature.

1. Press “PROG” until “AH” flashes

2. Press “PROG” 4 times “C=12”

appears.

3. Press “UP” or “DOWN” buttons to

change.

4. Press “LIGHT” button to clear or

wait 30 seconds.

B. SKIM–AWAY (ONLY AVAILABLE WITH

OPTIONAL CIRCULATION PUMP)

S k i m – A w a y i s a n a u t o m a t i c s k i m m i n g

action which takes place each day from

8am until 8:30am each morning and

from 4pm until 4:30pm each afternoon. The

primary and secondary pumps will activate in

low speed mode. This will pull all surface oils

and debris into the filter well cavity. This set-

ting permits the skim-away feature to operate

for 30 minutes each morning and afternoon

for a total of 1 hour each day.

1.Press and hold “PROG” until “AH” flashes.

2.Press “ P R O G ” three times to show

“SA=1” which is the factory setting.

3.

Pressing the “UP” or “DOWN” arrows, you

can change the skim-away tim to 2, 4, or 6

hours each day.

The total selected time will be split between

morning and afternoon.

Econo Package / LC Upgrade:

Your spa has been full foamed at the time

it was manufactured and is equipped with a

circulation pump. After the first twelve

hours of operation each day, as a protection

against overheating, the pump will turn off if

the water temperature exceeds the desired

temperature. The pump will comeback on

when the water temperature falls 1 degr e e

Fahrenheit under the desired temperature.

This will then activate the heater.

PAGE 17

I. DIAGNOSTIC

When in temperature set mode ( Heat

Icon Flashing ), then slowly press the

“PROG” button three times.

When the

screen reads P=2 or P=1 press the “PROG

button once again.

S=3 Indicates that the heater will stay on

when the pumps are on at anytime. High

or Low speed.

S=2 Indicates that the heater will shut off if

either of the large pumps are turned on

high speed

S=1 Indicates that the heater will only run

when the primary pump is on low speed.

Since the heater is associated with the

HEET pump system, the primary pump

does not need to be on for the heater to

operate. Yet in an effort to control the

amperage draw and conserve electricity,

the heater will run if the primary pump is

turned onto low speed but then shut off

while the primary pump goes to high

speed or if the secondary pump is

turned on high. Once the power level

has been set, this does not have to be

set each time. It will be entered into the

system memory.

Press the “PROG” button once again.

The diagnostic test will commence and

run for the next three and a half minutes.

Anytime during the first minute of testing,

you can stop the test by pressing the

“PROG” button once.

Upon completion of the test, if

everything is operating correctly, the

message GOOD will be displayed for 30

seconds.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Comments to this Manuals

No comments