Vita Spa L100 Series Owner's Manual download pdf (Page 27)

PAGE 24

D . A I R I N J E C T I O N / V I TA R O MA BU T TO N

Your spa is equipped with an air therapy

pump. A touch of the pump button

activates the power-mode for air bubble

action and induction of air into the

VitAroma (aromatherapy) system.

Touching the blower button again will turn

it off. For safety, the pump will

automatically turn off after 30 minutes.

To reactivate, start sequence over.

E. TURNING ON THE LIGHT

Your spa has an underwater light. A single

touch of the Light button turns the light

on. A second touch turns the light off. If

left on, the light will automatically turn off

after three (3) hours of continuous

operation.

F. I N V E R T I N G D I S P L AY

The Selectron Plus display can be

inverted to allow easier reading from

inside the spa. To do so, first make sure

“TIME” is displayed. Use “VIEW” button

to change to “TIME” display if needed.

Then press the “ D OW N ” arrow for

approximately 10 seconds to invert the

display. Follow the same procedure to

r e v e r t t h e v i e w b a c k t o i t s o r i g i n a l

position.

A . D I S PLAY ING TIME OR TEMPE RAT URE

Pressing the “VIEW” button will switch the

display between current time and current

water temperature.

T E M P O R A RI LY A D JU S T ING T E MP E RAT U R E

If you like to temporarily change your water

temperature setting, up or down, during any

one day, you can do so for the current day

by switching to the current temperature

display (press “VIEW”) and by pressing the

“UP” or “DOWN” arrows. The “adjusted”

temperature will be in effect until midnight

that day, at which point, the temperature

setting will revert back to the original setting

for that day. Notice the flashing heater icon

while making this change.

C. WATER JET THERAPY

Your spa is equipped with one or two

2-mode therapy pumps. The soft-mode

(Low) provides soft Relaxation Therapy and

the power-mode (High) provides vigorous

Power Therapy.

DUAL PUMP SYSTEMS:

Press “JET ” t o a c t i v a t e t h e R e l a x a t i o n

Therapy mode. Both pumps will turn on to

service every seat.

Press “JET” to activate the Power Therapy

mode. Pump #1 will turn on.

Press “JET” to activate pump #2 in Power

Therapy mode. Both pumps will be on.

Press “J ET” to de-activate pump #1.

Pump #2 will remain in Power Therapy

mode.

Press “JET” to de-activate pump #2. Both

pumps will be off.

Note that for safety, all jet modes will automatically

turn off after 30 minutes. Re-activate any therapy

mode as indicated above.

U S I NG YO U RSPA

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Comments to this Manuals

No comments

Vita Spa L100 Series Owner's Manual Page 27

Comments to this Manuals

Related products and manuals for Above ground pools Vita Spa L100 Series