Vita Spa L100 Series Owner's Manual download pdf (Page 19)

PAGE 16

minute, if the water is still below 50

degrees F (10 degrees Celsius), the heater

will turn on and raise the water temperature

10 degrees F.

F. FLOW PROTECTION

If the flow of water through the heater is

insufficient, the spa controller will automat-

ically turn the heater off to prevent over-

heating. The display will show “FLO”, indi-

cating a flow restriction caused by a clogged

filter, shut gate valves or by a malfunction in

the pressure switch. Call for service if you

cannot pinpoint the cause.

G. OVERHEAT PROTECTION

If the water temperature inside the spa

plumbing reaches 112 F, the display will

show “HILI” (High Limit), the heater will be

disabled, and the pumps will be turned on

low speed. If the water temperature contin-

ues to rise and reaches 115 F due to fric-

tion in the pumps and plumbing system,

the entire system including all pumps will

be disabled. In “HILI” condition, DO NOT

ENTER THE WATER. Remove the cover and

allow the water temperature to cool down

to 104 F. Then, reset the system by holding

down the “PROG” button for 5 seconds

while in time display mode. If the “HILI”

message returns, call for service.

H. ADD START UP CHEMICALS

Carefully follow the directions and add the

start-up chemicals recommended to you by

your dealer. Contact your dealer to clarify

any questions you may have.

Your spa comes ready for the Vita exclusive

“Sparkle Clear” natural mineral purifica-

tion cartridges. Combined with an ozonator,

“Sparkle Clear” will aid in reducing the need

for Bromine or other chlorine sanitizers.

Sparkle Clear and ozone will make your spa

look cleaner, smell cleaner, feel softer and

eliminate skin or eye irritation. Ask your

dealer about Vita Spa’s “Sparkle Clear”

sanitizing alternative.

C. TURNING ON THE LIGHT

Your spa is equipped with an underwater

light. Press the light button to activate and

de-activate the light. If left on, the light will

automatically turns itself off after 3 hours.

B. MEMORY

All settings that are entered into your spa

controller will be permanently retained in

its solid-state memory. In the event of a

power failure, the time will be captured and

held until power returns. All settings existing

at the time of the power failure will be

restored when power returns.

C. SYSTEM RESET

Anytime there is reason to believe that your

spa electronic system is not operating prop-

erly, perhaps as a result of lightning or other

interference, like your PC at home, your spa

system can be simply reset by holding

down the “DOWN” arrow button for 5 sec-

onds while in the time display mode. The

system will be reset, maintaining all the set-

tings you had in memory.

D. PANEL LOCK

The spa panel can be locked to keep chil-

dren or others from using any of the spa

functions. To deactivate all buttons, make

sure “Time” is displayed. Use “PROG”

button to change to “Time” display if need-

ed. Then hold the “UP” arrow button for 5

seconds. Notice the flashing lock icon. The

panel is locked. To unlock the panel, hold

the “UP” arrow button for 5 seconds again.

The flashing lock icon will disappear and all

spa functions will be accessible.

E. FREEZE PROTECTION

If temperature in the spa plumbing falls

below 50 degrees Fahrenheit (10 degrees

Celsius) the water pump(s) will turn on

soft-mode and run for at least one minute.

The display will show “ICE”. After one

S P ECIAL FE AT U RES

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Comments to this Manuals

No comments