Vita Spa Spa Owner's Manual download pdf (Page 46)

45

Owner’s Manual

English

GFCI TEST FEATURE

The Ground Fault Circuit Interrupter (GFCI) is

an important safety device and is required

equipment on a hot tub installation.

Used for verifying a proper installation, the

GFCI Trip Test must occur to allow proper spa

function. Within 7 days after startup, the spa

will trip the GFCI to test it. The GFCI must be

reset once it has tripped. After passing the

GFCI Trip Test, the spa will operate normally.

AUXILIARY PANEL

Selected models are equipped with an

auxiliary control panel which allows you to

operate pumps and the internal light without

leaving the comfort of your seat.

JETS 1

Touch the ‘JETS 1’ pad to activate the primary

ltration pump. The sequence of the jet action is:

1 touch = Low therapy jets

2 touches = High therapy jets

3 touches = O

JETS 2

Touch the ‘JETS 2’ pad to activate the second

therapy pump. The sequence of jet action is:

1 touch = High therapy jets

2 touches = O

Auxiliary Control Panel

THERAPY SEQUENCER

Certain models are equipped with a Jet

Sequencer System that opens and closes a

series of four solenoid valves to provide a

therapeutic sequencing massage.

The control panel for the system allows you

to start or stop operation, change programs,

change speeds, or pause the system at any

point in the program.

Starting the Sequencer

To energize the sequencing system, press the

‘JETS 3’ button on the topside control panel.

Once energized, the sequencer will open all 4

solenoid valves and water will ow through all

open jets. Two dashed lines will be displayed

in the LCD window.

Push the ‘ON/OFF’ button one time and the

LCD display will now show ‘On’. This indicates

that the system has been activated, but no

changes will occur until a sequencing program

has been selected.

Sequencing Programs

To start the sequencing program, push

the ‘PROG’ button one time. The LCD will

momentarily display ‘P2’, and then alternate

between ‘P2’ and ‘S1‘’. The system is now

running program 2 and sequencing speed 1.

To change programs, push the ‘PROG’ button

to step through the programs. The LCD will

momentarily display the selected program (P3,

P4, P5, etc.), and then alternately display the

selected program with the sequencing speed.

Refer to the chart on the next page to see the

order in which the valves will open and close

for each program.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 72 73

Comments to this Manuals

No comments