Vita Spa Spa Owner's Manual download pdf (Page 39)

38

Owner’s Manual

English

RESTRICTING OPERATION

The control can be restricted to prevent un-

wanted use or temperature adjustments.

From the main screen, activate temperature

ashing. While temperature is ashing, press

“Light” repeatedly until “LOCK” appears on the

screen. Pressing the temperature up button

allows you to toggle through “TEMP”, “OFF”

and “ON”.

“TEMP” allows you to lock the temp./settings.

“ON” allows you to lock all settings/functions.

“OFF” does not lock the spa.

UNLOCKING

This Unlock sequence may be used from any

screen that may be displayed on a restricted

panel.While pressing and holding the Temper-

ature Up button, slowly press the Light button

twice. “UNLK” will display on the screen and

after a few seconds, will revert to main screen.

ADJUSTING FILTRATION

Main Filtration

Filter cycles are set using a start time and a

duration. Start time is indicated by an “A” or

“P” in the bottom right corner of the display.

Duration has no “A” or “P” indication. Each set-

ting can be adjusted in 15-minute increments.

The panel calculates the end time and displays

it automatically.

To enter lter cycles, activate temperature

ashing and press the “Light” button repeat-

edly until the display reads “FLTR” (with a 1 in

the bottom right corner). Pressing the Light

button will bring you to the display “BEGN”.

The numbers ashing indicate numbers that

can be changed. Scroll through with the up

and down temperature buttons to choose

what time your lter cycle will start and press

the Light button to make your choice. “RUN”

“HRS” will be on the display next. Again, scroll

through the numbers to choose the duration

of your lter cycle.

Filter Cycle 2 - Optional Filtration

Follow the same procedures under “FLTR”

(with a 2 in the bottom right corner) to set up

lter cycle 2.

It is possible to overlap Filter Cycle 1 and Filter

Cycle 2, which will shorten overall ltration by

the overlap amount.

Purge Cycles

In order to maintain sanitary conditions, sec-

ondary Pumps and/or a Blower will purge wa-

ter from their respective plumbing by running

briey at the beginning of each lter cycle.

If Filter Cycle 1 is set for 24 hours, enabling

Filter Cycle 2 will initiate a purge when Filter

Cycle 2 is programmed to begin.

WiFi-CONNECTIVITY

See pages 48-51 to read about your spa’s Wi-Fi

capabilities. Some spas are equipped with

full Wi-Fi. See your dealer for details if you are

unsure of what your spa should receive.

GFCI TEST FEATURE

A GFCI is an important safety device and is

required equipment on a hot tub installation.

Your spa may be equipped with a GFCI Protec-

tion feature. If so, a GFCI Trip Test must occur

to allow proper spa function.

Within 7 days after startup, the spa will trip the

GFCI to test it. The GFCI must be reset once it

has tripped. After passing the GFCI Trip Test,

the spa will operate normally.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 72 73

Comments to this Manuals

No comments