Vita Spa Spa Owner's Manual download pdf (Page 12)

11

Owner’s Manual

English

JETS AND AIR CONTROLS

Jets

All spa jets are individually engineered

to provide a unique hydro-massage.

Depending on the model, your spa will have a

combination of the following jets.

Directional Jets

Positioned to focus on large muscle groups,

these jets deliver a concentrated, high volume

stream of water for a deep massage. Each jet

is fully adjustable, allowing users to set the

water ow to the most comfortable setting.

Nozzle can be rotated to target sore muscles.

Rotating Jets

Positioned to focus on muscle tension zones,

these jets deliver a spinning V-shaped water

stream for a gentle, pulsating massage. Each

jet is fully adjustable, allowing for comfortable

water ow settings for everyone to enjoy.

Euro Jets

Positioned in the foot well or shoulder areas,

these jets deliver a penetrating massage to

dissolve tension. This jet may be the entry

point for ozone produced during automatic

ltration and therefore it is not adjustable.

Note: Ozone production is stopped when

functions are activated on control panel.

Cleaning or Replacing Jets

Hard water can cause calcium/mineral

buildup that can restrict or bind the jets. A jet

consists of a face plate and a nozzle. Rotate

these parts weekly and remove/clean monthly

to ensure free movement.

NOTE: It is not necessary to drain the spa to

clean or remove the jets.

Rotating Jets

• Rotate the jet face left and right

• Return face plate to full open position

• Turn the jets on high speed

• Twist the nozzle left and right

• Rotate the nozzle in the socket

NOTE: If the jet insert disengages from the

spa housing, see steps to reinstall below.

Cleaning Jets

• To REMOVE the jet insert, use the palm of

your hand to exert pressure on the face of the

jet. Turn counterclockwise until the jet ‘clicks’.

Gently pull the jet assembly from the housing.

• To CLEAN the jet insert and housing, use a

pressurized hose and spray the inside of the

jet. Soak the jet in a diluted spa cleaning

solution, rinse. Wipe the inside of the housing

to remove any debris.

• To REINSTALL the jet, line up the tab on

the backside of the barrel with the groove in

the body. Use the palm of your hand to gently

tap the jet until it snaps into position.

NEVER SHUT ALL FULL SIZED

JETS OFF AT ONE TIME!

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 72 73

Comments to this Manuals

No comments