Vita Spa LD-15 Series Owner's Manual download pdf (Page 13)

PAGE 10

OPERAT I NG INST RUCT IONS

NOTE: For best results, read each step

carefully and entirely before proceeding

to the next.

FILLING YOUR SPA

Do not turn on the power to the spa. Wipe the

interior of the spa with a damp, soft cloth to

remove any residue that may be on the

surface. Fill with a garden hose by inserting the

nozzle of the hose in the filter inlet. (After filling

is complete, remember to put the filter

cartridge in place prior to starting the spa.) As

the spa is filling, check in the equipment

access area for any leaks. On occasion, it may

be necessary to hand tighten a union fitting

that may have come loose during transit. Also

check that the gate valves are pulled out to the

open position and that the hose bib is closed.

Continue to fill to the water line.

TESTING THE GFCI

The GFCI is a very important safety device

and the National Electric Code requires

that all spas are GFCI protected.

The GFCI shuts off the electricity in a fraction

of a second if there is a short anywhere in the

system. It is recommended that the GFCI be

tested prior to each use. Test as follows:

1. Push the TEST button on the GFCI. The

RESET button will trip out, the top side

digital control LED display will go out. If this

does not happen, DO NOT USE SPA.

CALL YOUR DEALER FOR ASSISTANCE.

2. If the GFCI tests properly, firmly push the

RESET button back into place. The top side

digital control LED display will come back

on. If this does not happen, DO NOT USE

S PA. CALL YO U R DEALER FOR

ASSISTANCE.

3. If the GFCI trips by itself at any time, firmly

press the RESET button back into place and

perform the above tests. If this happens

more than once, DO NOT USE SPA. CALL

YOUR DEALER FOR ASSISTANCE.

TOP SIDE DIGI TAL CON T R OL

TOP SIDE CONTROL L-50

Your spa has been designed to be simple to

operate and maintain. It is equipped with state-

of-the art digital control with LED readout to

show temperature and time. The digital control

has been factory programmed for your

convenience. Once properly connected, press

the jet button to activate the low speed of the

pump. The heater will come on and heat the

spa. Default factory- programmed temperature,

time and filtration hours are 10 2 F, 12pm and

4 hours (F=4H) respectively. Those initial

settings can be changed by following the

instructions shown below.

A. Displaying Time or Water Temperature.

Pressing the "PROG" button will allow

switching the display between time and water

temperature.

B. Setting Temperature

1. Press the “PROG” button to display water

temperature.

2. Press the “UP” or “DOWN” arrow to select

the desired temperature.

WATER LINE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Comments to this Manuals

No comments