Vita Spa LD-15 Series Owner's Manual download pdf (Page 14)

PAGE 11

OPERAT I NG INST RUCT IONS

3 . Press the “PROG” button to exit the

programming mode.

C. Setting Time and Filtration Hours

1. Press and hold the “PROG” button for 5

seconds until the displayed hour start s

flashing.

2. Press the “UP” or “DOWN” arrow to select

the current hour.

3. Press the”PROG” button one more time to

display the minutes.

4. Press the “UP” or “DOWN” arrow to select

the current minutes.

5. Press the “PROG” button one more time to

display the filtration hours. F=4H (default)

will be flashing. Refer to “ Filtration Cycles”

section to determine the lengths of cycles

(F=4H or F=8H) you prefer.

6. Press the “UP” or “DOWN” arrow to select

the filtration cycle desired.

7. Press the “PROG” button to exit the

programming mode.

D. Auto Heat Operation

Your spa is equipped with a 2-speed pump. Th e

low speed operates during filtration and heating

cycles. Your selected water temperature will be

maintained automatically 24 hours a day. Th e

electronic thermostat will monitor your water

temperature at the top of each hour by cycling the

low speed pump for 2 minutes. If the spa water

temperature is below the set temperature, the

heater will be activated until the water

temperature reaches the set temperature, at

which point both low speed pump and heater will

turn off. If the water temperature is at the set

temperature, the low speed pump will turn off at

the end of the 2 minutes. The spa water will heat

about 1 to 3 degrees F per hour for 110 Vo l t

system and 3 to 5 degrees F for 220 Volt systems.

The maximum temperature is set at 104 F.

The pump hi-speed therapy mode can be

activated during those cycles. The heater will

stay on if needed to bring up the water

temperature. Note that for 110 Volt spas, the

heater will turn off when you turn on the Hi-

speed therapy pump mode.

E. JET Button

Your spa is equipped with one or two

therapy pumps that can be activated as follows:

Single Pump Systems:

1. Press "JET" to activate the Relax a t i o n

Therapy mode. (Low speed pump).

2. Press "JET" a second time to activate the

Power Therapy mode. (High speed pump).

3 . Press “JET button a third time to turn the pump

o f f. Note that the low speed pump will remain

on if the water temperature is below the set

temperature or if it is during filtration hours.

Note that for safety, Jet Power Therapy mode will

turn off after 30 minutes. Reactivate as needed.

Dual Pump Systems:

1. Press “JET” to activate the Relax a t i o n

Therapy mode. Low speed pump)

2. Press “JET” to activate pump #1 Power

Therapy mode. (High speed pump #1)

3. Press “JET” to activate pump #2 Power

Therapy mode. (High speed pump #2)

4. Press “JET” to de-activate pump #1.

5. Press “JET” to de-activate pump #2.

Note that the low speed pump will remain on if

the water temperature is below the set

temperature or if it is during filtration hours. For

safety purposes, Jet Power Therapy Mode will

turn off after 30 minutes. Reactivate as needed.

A LWAYS CHE CK THE WAT ER TEMPERAT U RE

PRIOR TO EN T ERI NG IN T O YOUR SPA .

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 34 35

Comments to this Manuals

No comments