Vita Spa LD-15 Series Owner's Manual download pdf (Page 18)

PAGE 15

SAFETY FEATURES

A. Freeze Protection

If the temperature in the spa plumbing falls below 50 degrees Fahrenheit (10 degrees celsius), the

water pump will turn on low speed and run for 30 seconds. After 30 seconds, if the water is still at

50 F, the heater will turn on and raise the temperature 10 Degrees. The top side control will display

the message "ICE" to indicate potential freeze conditions.

B. Flow Protection

If the flow of water through the heater is insufficient, the spa controller will automatically turn off the

heater to prevent overheating. The display will show "FLO", indicating a flow restriction caused by a

clogged filter or pump impeller, a malfunction of the pressure switch or a defective pump motor. Refer

to the Trouble Shooting Chart. If you cannot pinpoint the cause, Call Your Dealer for technical assistance.

C. Overheat Protection.

If a malfunction occurs and the spa water temperature reaches 112F, the pump and heater will turn

off. DO NOT ENTER THE WATER. Remove the cover and allow the water temperature to cool down

to 104 F. Reset the system by holding the "UP" arrow for 5 seconds. See "Resetting Your Spa" page

12. The pump and heater will start normal operation. If this happens a second time in a row, T URN

T H E POWER TO THE SPA OFF AND CALL YO UR DEALER FOR ASS I STA N C E.

If there is an overheat condition in the spa heater, the display will show the message "HILI". DO NOT

ENTER THE WAT E R. Remove the cover and allow the water to cool down to 10 4 F. Then reset the system

by holding down the "UP" button for 5 seconds. See "Resetting Your Spa" page 12. If the "HILI" message

returns, T URN THE POWER TO THE SPA OFF AND CALL YO UR DEALER FOR ASS I STA N C E.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 34 35

No comments

Vita Spa LD-15 Series Owner's Manual Page 18