Vita Spa LD-15 Series Owner's Manual download pdf (Page 15)

PAGE 12

OPERAT I NG INST RUCT IONS

F. LIGHT Button

Turns the spa light ON and OFF. If left ON, the light

will automatically go OFF after 9 hours.

G. Auxiliary Button

This button is not operational on U100 series spas.

H. Filtration Hours

Your spa digital control has an electronic timer

that has been pre-programmed to automatically

run the filtration low speed pump 2 hours twice

a day for a total of 4 hours (F=4H), from 8am

to 10am and from 4pm to 6pm. You have the

option of increasing the filtration time to 8 hours

per day (F=8H, from 6am to 10am and from

6pm to 10pm) depending on user load and on

the type of sanitizing system you use. For

instance, proper use of an ozonator requires 8

hours a day. To change your filtration time to 8

hours, please refer to section “B. Setting Time

and Filtration Hours”.

The heater will come on as needed during filtration

hours to maintain the water temperature. Note that

filtration will also be provided during the heating cycles

when the electronic thermostat monitor water

temperature at the top of each hour and maintain the

low speed pump when additional heat is needed.

I. Memory

The temperature setting that is entered into your

spa digital topside control are permanently

retained in its solid state memory. In the event

of a power failure, the temperature and time

settings will be captured and held until power

returns. The temperature setting at the time of

the power failure will be restored when power

returns. You will have to reset the time to actual.

J. Resetting Your Spa

Like your PC at home, your spa electronics could

get corrupted by electrical surges or spikes, or by

low voltage, resulting in improper operations.

Anytime there is reason to believe that your spa

system is not operating properly, please follow

the following resetting procedure:

1 . Turn the power to the spa off for 5 full minutes.

2 . Turn the power back on.

3 . Press “PROG” to show time.

4 . Press and hold the “UP” arrow for 5

seconds. The top side display will show

12:00 PM as soon as you release the “UP”

arrow indicating a successful reset. The

set temperature and filtration hours will

be reset to their factory pre-programmed

settings of 102F and 4HR respectfully.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Comments to this Manuals

No comments

Vita Spa LD-15 Series Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Above ground pools Vita Spa LD-15 Series