Vita Spa DUET Operations Instructions download pdf (Page 7)

6

VITA SPA DUET

SPA INSTALLATION

Danger: Electrical shock risk. Install at

least 1.5m from all metal surfaces.

The electrical supply for this product must

include a suitably rated switch or circuit

breaker to open all ungrounded supply

conductors to comply with Section 422-20

of the National Electrical Code ANSI/NFPA70-

2008. The disconnecting means must be

readily accessible but installed at least 6 feet

(1.8 meters) from the spa water. All electrical

connections should comply with article 680-IV

of the NEC.

Site and Positioning

Locate the spa on solid, level foundation or

 ooring, keeping in mind the weight of the

 lled spa [in excess of

4,000 bls. (1.800 kg.)

on

some models]. If you have any doubts about

the load bearing ability of your chosen site,

contact an architect or a building contractor.

The entire perimeter of the spa cabinet and

the spa bottom must be evenly supported.

If your spa is installed outdoors, we

recommend that you provide a concrete pad

for the spa to rest on 8ft x 8ft x 4in (2,5m x

2,5m x 10cm level pad). Failure to provide

a  at level surface could structurally

damage your spa and void the warranty.

The spa must be installed to allow access for

service and maintenance on all four sides;

therefore, below grade level installation is

not recommended.

Outdoor Installation

The following considerations apply when

installing your spa outdoors:

1. Local codes pertaining to fencing.

2. Local electrical and plumbing codes.

3. View from your house.

4. Wind direction.

5. Exposure to sunlight.

6. Location relationship to trees (twigs,

leaves and shade).

7. Dressing and bathroom location.

8. Storage area for maintenance equipment

and chemicals.

9. Location to facilitate adult supervision.

10. Landscaping and nighttime lighting.

11. Accessibility to equipment.

12. Power supply location and foot tra c.

Indoor Installation

The following considerations apply when

installing your spa indoors:

1. Indoor spas promote high humidity. Using

either ventilation fans or commercial

grade de-humidi ers will help to reduce

the humidity. Consult your dealer for

details.

2. Floor drains must be provided near the

spa to drain o water that may cause

falls and /or water damage.

3. Floor area should be  at with a non-skid

 nish. Carpeting is not recommended.

4. Walls, ceilings, woodwork should be made

of materials capable of withstanding high

humidity (redwood, cedar).

5. Be sure  oor load bearing capacities are

adequate to support the concentrated

spa weight.

6. Spas should be double checked for leaks

before installing to avoid possible water

damage. Dealer installation may include

this service.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments