Vita Spa DUET Operations Instructions download pdf (Page 13)

12

VITA SPA DUET

ELECTRICAL INFORMATION

Important Safety Instructions

All electrical connections to this spa package

MUST be accomplished by a quali ed

licensed electrician in accordance with

National Electrical Code (NEC) and with state/

local electrical codes in e ect at the time of

installation.

NOTE: Prior to performing any service to

the spa equipment, turn OFF all primary

electrical power at the main circuit breaker

or disconnect panel.

To make spa electrical connections, remove

the exterior equipment pack service panel,

locate the electrical control box, remove

the control box cover and follow the wiring

diagram on the inside of the control box cover.

Connections should be made using copper

conductors only. Connecting wires, circuit

breakers, or fuses must all be sized to

accommodate the Total Ampere load as

speci ed on the equipment label.

This equipment is designed to operate on

60Hz alternating current only, at 120 volts.

NOTE: All unions must be hand-tight and

all slice valves must be locked in the OPEN

position before  lling or re lling spa!

A clip is provided to help keep the slice

valve open. Run spa and check for union

water leaks before reinstalling exterior

panel.

Ground-Fault Circuit Interrupter

A quali ed licensed electrician shall connect

the spa to a circuit protected by a GFCI. This

is a requirement by the National Electric

Code, article 680-42 and 680-43, and is also in

compliance with Underwriter’s Laboratories,

Inc.

Installation Options

A hole will need to be drilled in the pedestal

or base to bring the electrical conduit into

the spa cabinet.

Refer to the manufactures’s nameplate

located on the kick plate to determine your

spa’s ampere requirements.

The Model Duet comes factory set for 120

volt service.

Electrical Requirements:

120 Volt Installation

• 120 volt, 60 Hz, single phase, 15 amp.,

3-wire service (line 1, neutral, and

ground)

The heater can only be activated with the

pump on low speed. Only the spa light

can be operating at the same time without

disabling the heater.

Caution: Risk of electrical shock.

Read and follow all instructions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments