Vita Spa Spa Owner's Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
PAGE 13
OPERATING INSTRUCTIONS
NOTE: For best results, read each
step carefully and entirely before
proceeding to the next.
FILLING YOUR SPA
Wipe the interior of the spa with a damp,
soft cloth to remove any residue that
may be on the surface. Fill with a garden
hose by inserting the nozzle of the hose
in the filter inlet. (After filling is complete,
remember to put the filter cartridge in
place prior to starting the spa.) As the
spa is filling, check in the equipment
access area for any leaks. On occasion, it
may be necessary to hand tighten a
union fitting that may have come loose
during transit. Also check that the gate
valves are pulled out to the open position
and that the hose bib is closed. Continue
to fill to the water line.
NOTE: If your water is extremely hard, it
is preferable to fill the spa halfway with
hard water and the rest with softened
water. Never fill the spa entirely with
softened water.
INITIAL START UP
Your spa has been programmed for your
convenience. Once properly connected,
the pump and heater will automatically
come on, heat the spa to 102 F. Initial
temperature, day, and time can be set
and changed by following these
instructions.
WATER LINE
A. SETTING TEMPERATURE:
1. Press “PROG” to display water
temperature.
2. Press “UP” or “DOWN” arrows to
choose the desired temperature.
Notice the heater icon flashing.
3. Wait 30 seconds or press any function
buttons (“Jet” or “Light”) to exit the
programming mode.
“F” FAHRENHEIT OR “C” CELSIUS DEGREES
Your spa has been preset to show the
temperature in Fahrenheit “F” degrees. If
you desire, you can change to Celsius
“C” degrees by entering the temp set
routine(Display temperature and then
touch the up or down arrow). Then while
the numbers are flashing, hold the light
button for 10 sec. When the “F” or “C”
appears, use the up or down buttons to
toggle. To exit this procedure, wait 30
seconds or press any button.
B. AUTO HEAT AND ECONOMY MODE
(NOT AVAILABLE WITH CIRCULATION
PUMP OPTION)
Your spa has been designed to operate
in two heater control modes: AUTO
HEAT (“AH”) and ECONOMY (“ECO”).
In the AUTO HEAT mode, the pump and
heater will turn on whenever the water
temperature falls 1 degree below the
chosen temperature . Your spa has been
preset to start upon activation in the
AUTO HEAT mode. The spa water will
be automatically heated to the
temperature you choose or to the preset
temperature of 102 F.
In the ECONOMY mode, the pump and
heater will only come on during
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments